Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    Journal of molecular medicine 63 (1985), S. 241-251 
    ISSN: 1432-1440
    Keywords: HCMV isolation ; Antigen and nucleic acid detection ; Ig class-specific antibody determination ; Risk groups: pregnancy, blood transfusion, organ transplantation
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine
    Notes: Summary Cytomegalic inclusion disease (CID) is caused by a horizontally or vertically transmitted human herpes virus infection and may persist for life without obvious clinical symptoms. A serious course of horizontal primary and recurrent infections, however, is often observed in immunocompromised persons such as recipients of organ transplants and patients receiving fresh blood transfusions. Vertical infection may cause fetopathies. The human cytomegalovirus (HCMV) is thought to inherit an oncogenic potential as lately discussed for AIDS and M. Kaposi. Laboratory diagnosis of HCMV infection is performed by light microscopy (inclusion bodies), electron microscopy, virus isolation in cell culture, demonstration of viral DNA and antigen in clinical specimens, by histochemical methods (e.g. immunoperoxidase technique) and by DNA and peptide analysis for identification of different isolates and viral finger prints. Evaluation of cell-mediated immunity in HCMV infection is performed quantitatively (assessment of Thelper/Tsuppressor ratios) or qualitatively (specific lymphocyte stimulation by the antigen). In most cases laboratory diagnosis is achieved by serological methods, i.e. demonstration and quantitation of HCMV-specific antibodies. In this context, a number of liquid- and solid-phase immunoassays have been developed, of which immunofluorescence and ELISA are most commonly used, besides complement fixation and passive haemaglutination. These procedures on the one hand allow the use of different antigen preparations as early and late viral proteins, and on the other hand permit a specific determination of different Ig classes and subclasses. A variety of assays has been established especially for determination of virus-specific IgM antibodies, which are predominantly found in active infection. These, however, at least in part may show non-specific results caused by interference of rheumatoid factor or IgG competition. Such problems have now been dealt with and are avoided by IgG precipitation or IgM immunosorption (“μ-capture” technique). These recent methods allow an exact epidemiological identification of risk groups for CMV infection. Results from our laboratory revealed 13% HCMV-IgM positive patients among pregnant women, 16% IgM positive patients among renal transplant recipients, 4% igM positive cases in patients after cardiosurgery and 1.7% IgM positives among prostitutes. The prevalence of HCMV infection as indicated by specific IgG antibodies was 56%, 90%, 83%, and 90%, respectively. No IgM antibodies were found in haemophiliacs and healthy blood donours, which showed a prevalence of HCMV infection in 69% and 47% of tested serum samples.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 10 (1968), S. 33-43 
    ISSN: 0006-3592
    Keywords: Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The growth of batch-cultivated yeast Candida lipolytica on three kinds of gas oil using mineral medium was studied. A linear dependence was found between the production of yeast biomass and the consumption of n-alkanes, while the decrease of freezing point of gas oil during cultivation had a distinct course. This disproportion was explained by different degradation of individual n-alkanes contained in gas oil. The rate of degradation of pentadecane, hexadecane, and heptadecane was the same during the entire cultivation. On the contrary, in the first phase the utilization of shorter chain n-alkanes, nonane to tetradecane, was more rapid while that of longer chain homologs, octadecane to pentacosane, lagged. Rapid utilization of longer chain n-alkanes did not occur before the concentration of the other n-alkanes decreased. Only then the rapid decrease of freezing point appeared.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 11 (1969), S. 383-391 
    ISSN: 0006-3592
    Keywords: Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The results achieved by the cultivation of the yeast. Candida lipolytica on gas oil are referred. By using a distillation fraction of gas oil distilling between 180-400°C, containing 10-20% of n-alkanes, the optimal condition for biomass production and deparaffination were estimated for various dilution rates and various amounts of gas oil in the medium. The main factor, which influences the yield coefficient by hydrocarbon fermentation is the polyauxie of the hydrocarbon substrate. The penetration of dispersed hydrocarbons into the yeast cell is demonstrated on electron micrographs and the velocity and reversibility of this process is estimated by using tritium-traced hexadecane.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 10 (1968), S. 865-875 
    ISSN: 0006-3592
    Keywords: Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Continuous cultivation of the yeast Candida lipolytica on gas oil was studied from the viewpoint of biomass production and oil deparaffination. Optimum conditions wore found at the dilution rate D = 0.16-0.19 when biomass productivity 1.7 g/l/hr and yield coefficient. y = 0.92 were achieved. At deparaffination to the same freezing point, more than double the production of biomass and deparaffined oil during a given time unit was achieved in a continuous process than in batch cultivation. Consumption of substrate was followed in both cultivation processes and it was confirmed that individual n-alkanes of gas oil were degraded at various rates and yields. Results proved optimum cultivation conditions to depend on concentration and composition of the paraffinic fraction of gas oil used. To achieve these conditions the continuous process may be controlled by choice; of suitable dilution rate and concentration of gas oil.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Weinheim : Wiley-Blackwell
    Electroanalysis 6 (1994), S. 945-952 
    ISSN: 1040-0397
    Keywords: Silver electrode ; Silver chloride ; Reference electrode ; Plasma ; Blood ; Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: The preparation in situ of a silver-silver chloride reference electrode includes anodic-cathodic pretreatment of a silver electrode in a phosphate buffer solution comprising 0.1 M sodium chloride. At pH 7.0 and 25°C and with optimally pretreated electrodes, the potential of the Ag/AgCl electrode was 45.0 mV (vs. SCE) with a reproducibility of 0.2%. In a period of 30 seconds following a delay of 2 to 10 seconds, the electrode shows a very stable potential that changes only 0.2 to 0.3%. The electrode potential changes 0.3 mV/°C. The electrode shows nernstian dependence of the potential to the sodium chloride concentration. At the physiological level, the only electrochemically active compound that significantly influences the potential of the electrode is reduced glutathione. Paracetamol (0.2 mM) and uric acid (0.27 mM) after slightly the electrode potential. The electrode parameters in plasma are close to those of phosphate buffer solution, whereas in artificial blood, the reproducibility and the stability of the potential decrease. The reproducibility and stability of the electrode potential in capillary blood was 1.4 and 3.7%, respectively.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Bognor Regis [u.a.] : Wiley-Blackwell
    Journal of Polymer Science Part B: Polymer Physics 33 (1995), S. 1713-1722 
    ISSN: 0887-6266
    Keywords: block copolymers ; micelles ; solubilization ; light scattering ; Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Block copolymers, when dissolved in a selective solvent, form spherical micelles. These micelles can selectively solubilize organic molecules otherwise insoluble in the pure solvent. In this study, we report solubilization of organic molecules by styrene-methacrylic acid block copolymer micelles in aqueous buffers. A light scattering technique was developed to determine the extent of micellar solubilization. Our results indicate that the extent of micellar solubilization depends on the chemical nature of organic molecules, specifically, on the interactions between the organic compound and polystyrene. A thermodynamic model has been developed to describe micellar solubilization. The theoretical calculation agrees reasonably well with the experimental results for two micellar samples examined. ©1995 John Wiley & Sons, Inc.
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...