Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    The European physical journal 188 (1965), S. 378-384 
    ISSN: 1434-601X
    Source: Springer Online Journal Archives 1860-2000
    Topics: Physics
    Notes: Abstract The behaviour of Semiconductor Surface Barrier Detectors has been studied in the temperature range from 300 °K to 4.2 °K. Measurements of the resolution forα- andβ-particles are given. The mean energyɛ required for producing an electron-hole-pair in Si is found to be 3.54±0.10 eV at 279 °K, and 3.72±0,11 eV at 78 °K and 4.2 °K respectively. Measured rise time of detector impulses is compared with theoretical values.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Springer
    Czechoslovak journal of physics 39 (1989), S. 998-1006 
    ISSN: 1572-9486
    Source: Springer Online Journal Archives 1860-2000
    Topics: Physics
    Notes: Abstract The formulas of the dependence of the spectral laser power distribution and its spectral half-width on the physical parameters of its laser active medium are derived. In addition it is found that, if the gain line profile has a Lorentzian or Gaussian distribution, the spectral laser power distribution is of a Lorentzian profile. The spectral halfwidth of the laser beam in both cases are slightly different form each other. For a general gain line profile, the spectral laser power distribution behaves as a differential form like that of the gain line profile. The spectral halfwidth of He/Ne laser beam having powers (0·5 mW, 1·0 mW, 3·0 mW and 50 mW) and that of their longitudinal modes, the laser gain factor and the difference between the population atomic densities of the upper and lower energy levels for the laser line transition are experimentally determined.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Springer
    Czechoslovak journal of physics 41 (1991), S. 149-156 
    ISSN: 1572-9486
    Source: Springer Online Journal Archives 1860-2000
    Topics: Physics
    Notes: Abstract The effect of Sn solutes segregating into grain boundaries on the steady-state creep characteristics was studied for wires of a Cu-10 wt % Sn alloy having various grain diameters,d. The creep tests were performed for samples in theα-phase in the temperature range: (0·5–0·58 Tm). The steady state creep rate,ε s, was found to vary linearly withd. The variation in the stress sensitivity parameter,m, was found to be much less appreciable for large grains (〉50μm). Activation energy calculation showed that two competitive mechanisms are operating for creep deformation, namely, dislocation climb and viscous motion of matrix dislocations due to dragging of Sn atmosphere. A value of 6·74 kJ/mol was obtained for the binding energy between a Sn atom and the dislocation, while the binding energy between a vacancy and the Sn atom was found to be 33·71 kJ/mol.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Springer
    Czechoslovak journal of physics 39 (1989), S. 224-229 
    ISSN: 1572-9486
    Source: Springer Online Journal Archives 1860-2000
    Topics: Physics
    Notes: Abstract Stress-strain curves of slowly cooled and quenched Al-2·5 wt. % Cu alloy were studied in the temperature range 693 K to 773 K. The linear work-hardening coefficient, the fracture time, the yield stress and the fracture stress of annealed and quenched samples decreased with increasing deformation temperature and exhibited a minimum at 733 K. The X-ray analysis of the slowly cooled and quenched samples showed that the lattice parametera of Al-matrix and the ratioc/a of the tetragonal Θ-phase reached a minimum and a maximum value, respectively, at the dissolution temperature.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Czechoslovak journal of physics 45 (1995), S. 275-282 
    ISSN: 1572-9486
    Source: Springer Online Journal Archives 1860-2000
    Topics: Physics
    Notes: Abstract The effect of temperature and carbon black (CB) on the mechanical characteristics of styrene-butadine rubber (SBR) and natural rubber (NR) was studied at various temperatures. The relation obtained between true stress and true strain for both types of rubber showed three regions at room temperature and two regions at high temperature. The optimum CB concentration was found to be 95 phr for the unblended samples as it increases the stiffness of the SBR rubber materials at a maximum value. It was also found that the addition of NR to SBR increases the elasticity in the plastic region. The activation energy at the fracture of SBR samples decreased from about 2.7×10−20 to 1.8×10−20 J while for the blended samples NR/SBR it increased from 8×10−20 to 10.1×10−20 J with increasing CB concentration.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    ISSN: 1432-0630
    Keywords: 78.50
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Abstract Ternary ZnSxSe1−x polycrystalline thin films were prepared by evaporation in vacuum of 10−5 Torr. The molecular fractionx varied in the region o≦x≦1. The optical constants (the refractive indexn, the absorption indexk, and the absorption coefficientα) were determined in the wavelength range 300–1600nm. A plot representingα 2=f(hv) shows that the ZnSxSe1−x polycrystalline thin films of different compositions have two direct transitions corresponding to the energy gapsE andE+Δ. The variation in eitherE orE+Δ withx indicates that this system belongs to the amalgamation type. Such variation follows a quadratic equation. The bowing parameter was found to be 0.456 eV, roughly equal to the calculated value 0.60 eV using the empirical pseudopotential method based on the virtual-crystal approximation, in which the disorder effect has not been taken into account.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    ISSN: 1432-0509
    Keywords: Kidney donors ; Digital subtraction angiography
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine
    Notes: Abstract Intravenous digital subtraction angiography (IV-DSA) combined with excretory urography (IVU) were utilized to study the renal anatomy of 1000 potential live-kidney donors. In the entire series, 712 donors (71.2%) had bilateral single renal arteries, whereas 255 (25.5%) had unilateral multiple, 26 (2.6%) had bilateral multiple, and 7 (0.7%) had unilateral hypoplastic or absent renal arteries determined by IV-DSA. Major renal abnormalities that might be potentially significant for safe renal donation were detected in 76 donors (7.6%) by combined IV-DSA and IVU studies. In 10% of the potential donors, intraarterial digital subtraction angiography (IA-DSA) was required because of the equivocal results of IV-DSA. Of the 1000 potential donors, 700 underwent nephrectomy and the number of renal arteries at nephrectomy was compared with both IV-DSA and IA-DSA reports. Analysis of data revealed a sensitivity of 96% vs 95%, a specificity of 57% vs 75% and an overall accuracy 93% vs 90% for IV-DSA and IA-DSA, respectively. both IV-DSA and IA-DSA were accurate enough in identification of single renal arteries. However, the accuracy of IA-DSA was better than that of IV-DSA in visualization of double (84% vs 64%) and triple (66% vs 33%) renal arteries. It is concluded that IV-DSA combined with IVU is an effective technique for the evaluation of potential kidney donors. In cases where IV-DSA is equivocal, we recommend confirming IA-DSA.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Springer
    Journal of thermal analysis and calorimetry 46 (1996), S. 1697-1703 
    ISSN: 1572-8943
    Keywords: ammonium salts
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Notes: Abstract The thermal conductivity, specific heat capacity and thermal diffusivity of solid and molten ammonium thiocyanate, ammonium formate, ammonium acetate and ammonium nitrate were measured in the temperature range 80–190
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 1 (1990), S. 115-117 
    ISSN: 1573-482X
    Source: Springer Online Journal Archives 1860-2000
    Topics: Electrical Engineering, Measurement and Control Technology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract The a.c. photoconductivity of bulk polycrystalline In x Se1−x and the optical properties of amorphous In x Se1−x thin films were investigated. The effect of heat treatment on the absorption coefficient of InSe thin films was also studied. The spectral response of the photoconductivity of polycrystalline In x Se1−x related to the near-edge absorption spectrum, shows a well-defined maximum corresponding to the width of the forbidden gap. Polycrystalline In x Se1−x realizes the behaviour of photoconductors which are sensitive in a spectral range between 400 and 1700 nm. Optical absorption of amorphous In x Se1−x thin films was recorded as a function of photon energy and the data were used to deduce the value of optical energy gap of the films. It was found that the optical energy gap decreased with increasing indium content in both bulk polycrystalline and amorphous thin films. The effect of heat treatment on the optical gap of the film has been interpreted in terms of the density of states model of Mott and Davis.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Springer
    Journal of materials science 21 (1986), S. 3071-3077 
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract The effect of simultaneous additions of tungsten on the martensite (M) ⇌ austenite (γ) transformation, taking place during tensile deformation under different constant stresses and thermal cyclic rates for Fe-Ni-Co based maraging steel alloys was studied. The strain rate sensitivity parameterm was found to be 1.0 and 0.6 for the M →γ andγ → M transformations, respectively. The interpretation of deformation results implied a preponderantly diffusional mechanism in the M →γ transformation and a dislocation mechanism in theγ → M transformation. The increase of the lattice parameters of maraging steel alloys indicated that the hardening element, which is tungsten, was dissolved after tensile deformation.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...