Library

X
feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 2000-2004  (5)
Source
Material
Years
Year
  • 1
    Electronic Resource
    Electronic Resource
    Sustained rotational stabilization of DIII-D plasmas above the no-wall beta limit : Review,Tutorial and Invited Papers from the 43rd Annual Meeting of the APS Division of Plasma Physics (2002)
    [S.l.] : American Institute of Physics (AIP)
    Physics of Plasmas 9 (2002), S. 1997-2005 
    Details
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Sustained stabilization of the n=1 kink mode by plasma rotation at beta approaching twice the stability limit calculated without a wall has been achieved in DIII-D by a combination of error field reduction and sufficient rotation drive. Previous experiments have transiently exceeded the no-wall beta limit. However, demonstration of sustained rotational stabilization has remained elusive because the rotation has been found to decay whenever the plasma is wall stabilized. Recent theory [Boozer, Phys. Rev. Lett. 86, 5059 (2001)] predicts a resonant response to error fields in a plasma approaching marginal stability to a low-n kink mode. Enhancement of magnetic nonaxisymmetry in the plasma leads to strong damping of the toroidal rotation, precisely in the high-beta regime where it is needed for stabilization. This resonant response, or "error field amplification" is demonstrated in DIII-D experiments: applied n=1 radial fields cause enhanced plasma response and strong rotation damping at beta above the no wall limit but have little effect at lower beta. The discovery of an error field amplification has led to sustained operation above the no-wall limit through improved magnetic field symmetrization using an external coil set. The required symmetrization is determined both by optimizing the external currents with respect to the plasma rotation and by use of feedback to detect and minimize the plasma response to nonaxisymmetric fields as beta increases. Ideal stability analysis and rotation braking experiments at different beta values show that beta is maintained 50% higher than the no wall stability limit for durations greater than 1 s, and approaches beta twice the no-wall limit in several cases, with steady-state rotation levels. The results suggest that improved magnetic-field symmetry could allow plasmas to be maintained well above no-wall beta limit for as long as sufficient torque is provided. © 2002 American Institute of Physics.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1063/1.1446036
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 2
    Electronic Resource
    Electronic Resource
    Control of neoclassical tearing modes in DIII–D : Review,Tutorial and Invited Papers from the 43rd Annual Meeting of the APS Division of Plasma Physics (2002)
    [S.l.] : American Institute of Physics (AIP)
    Physics of Plasmas 9 (2002), S. 2051-2060 
    Details
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The development of techniques for neoclassical tearing mode (NTM) suppression or avoidance is crucial for successful high beta/high confinement tokamaks. Neoclassical tearing modes are islands destabilized and maintained by a helically perturbed bootstrap current and represent a significant limit to performance at higher poloidal beta. The confinement-degrading islands can be reduced or completely suppressed by precisely replacing the "missing" bootstrap current in the island O-point or by interfering with the fundamental helical harmonic of the pressure. Implementation of such techniques is being studied in the DIII-D tokamak [J. L. Luxon et al., Plasma Physics and Controlled Fusion Research (International Atomic Energy Agency, Vienna, 1987), Vol. 1, p. 159] in the presence of periodic q=1 sawtooth instabilities, a reactor relevant regime. Radially localized off-axis electron cyclotron current drive (ECCD) must be precisely located on the island. In DIII-D the plasma control system is put into a "search and suppress" mode to make either small rigid radial position shifts of the entire plasma (and thus the island) or small changes in the toroidal field (and, thus, the ECCD location) to find and lock onto the optimum position for complete island suppression by ECCD. This is based on real-time measurements of an m/n=3/2 mode amplitude dBθ/dt. The experiment represents the first use of active feedback control to provide continuous, precise positioning. An alternative to ECCD makes use of the six toroidal section "C-Coil" on DIII-D to provide a large nonresonant static m=1, n=3 helical field to interfere with the fundamental harmonic of an m/n=3/2 NTM. While experiments show success in inhibiting the NTM if a large enough n=3 field is applied before the island onset, there is a considerable plasma rotation decrease due to n=3 "ripple." © 2002 American Institute of Physics.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1063/1.1456066
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 3
    Electronic Resource
    Electronic Resource
    Active feedback stabilization of the resistive wall mode on the DIII-D device : The 42nd annual meeting of the division of plasma physics of the American Physical Society and the 10th international congress on plasma physics (2001)
    [S.l.] : American Institute of Physics (AIP)
    Physics of Plasmas 8 (2001), S. 2071-2082 
    Details
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A proof of principle magnetic feedback stabilization experiment has been carried out to suppress the resistive wall mode (RWM), a branch of the ideal magnetohydrodynamic (MHD) kink mode under the influence of a stabilizing resistive wall, on the DIII-D tokamak device [Plasma Phys. Controlled Fusion Research (International Atomic Energy Agency, Vienna, 1986), p. 159; Phys. Plasmas 1, 1415 (1994)]. The RWM was successfully suppressed and the high beta duration above the no-wall limit was extended to more than 50 times the resistive wall flux diffusion time. It was observed that the mode structure was well preserved during the time of the feedback application. Several lumped parameter formulations were used to study the feedback process. The observed feedback characteristics are in good qualitative agreement with the analysis. These results provide encouragement to future efforts towards optimizing the RWM feedback methodology in parallel to what has been successfully developed for the n=0 vertical positional control. Newly developed MHD codes have been extremely useful in guiding the experiments and in providing possible paths for the next step. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1063/1.1351823
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 4
    Electronic Resource
    Electronic Resource
    Modification of high mode pedestal instabilities in the DIII-D tokamak (2000)
    [S.l.] : American Institute of Physics (AIP)
    Physics of Plasmas 7 (2000), S. 1976-1983 
    Details
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The amplitude and frequency of modes driven in the edge region of tokamak high mode (H-mode) discharges [type I edge-localized modes (ELMs)] are shown to depend on the discharge shape. The measured pressure gradient threshold for instability and its scaling with discharge shape are compared with predictions from ideal magnetohydrodynamic theory for low toroidal mode number (n) instabilities driven by pressure gradient and current density and good agreement is found. Reductions in mode amplitude are observed in discharge shapes with either high squareness or low triangularity where the stability threshold in the edge pressure gradient is predicted to be reduced and the most unstable mode is expected to have higher values of n. The importance of access to the ballooning mode second stability regime is demonstrated through the changes in the ELM character that occur when second regime access is not available. An edge stability model is presented that predicts that there is a threshold value of n for second regime access and that the most unstable mode has n near this threshold. © 2000 American Institute of Physics.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1063/1.874053
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
  • 5
    Electronic Resource
    Electronic Resource
    Quiescent double barrier high-confinement mode plasmas in the DIII-D tokamak : The 42nd annual meeting of the division of plasma physics of the American Physical Society and the 10th international congress on plasma physics (2001)
    [S.l.] : American Institute of Physics (AIP)
    Physics of Plasmas 8 (2001), S. 2153-2162 
    Details
    ISSN: 1089-7674
    Source: AIP Digital Archive
    Topics: Physics
    Notes: High-confinement (H-mode) operation is the choice for next-step tokamak devices based either on conventional or advanced tokamak physics. This choice, however, comes at a significant cost for both the conventional and advanced tokamaks because of the effects of edge localized modes (ELMs). ELMs can produce significant erosion in the divertor and can affect the beta limit and reduced core transport regions needed for advanced tokamak operation. Experimental results from DIII-D [J. L. Luxon et al., Plasma Physics and Controlled Nuclear Fusion Research 1986 (International Atomic Energy Agency, Vienna, 1987), Vol. I, p. 159] this year have demonstrated a new operating regime, the quiescent H-mode regime, which solves these problems. We have achieved quiescent H-mode operation that is ELM-free and yet has good density and impurity control. In addition, we have demonstrated that an internal transport barrier can be produced and maintained inside the H-mode edge barrier for long periods of time (〉3.5 s or 〉25 energy confinement times τE), yielding a quiescent double barrier regime. By slowly ramping the input power, we have achieved βNH89=7 for up to 5 times the τE of 150 ms. The βNH89 values of 7 substantially exceed the value of 4 routinely achieved in the standard ELMing H mode. The key factors in creating the quiescent H-mode operation are neutral beam injection in the direction opposite to the plasma current (counter injection) plus cryopumping to reduce the density. Density and impurity control in the quiescent H mode is possible because of the presence of an edge magnetohydrodynamic (MHD) oscillation, the edge harmonic oscillation, which enhances the edge particle transport while leaving the energy transport unaffected. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    URL: http://dx.doi.org/10.1063/1.1355981
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
    Paper (German National Licenses)
    Fulltext
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...