Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: In situ resistance versus temperature or time for reactions between 32 and 57.5 nm of titanium and undoped or doped polycrystalline silicon (boron, arsenic, or phosphorus, 7.9×1019–3.0×1020/cm3) has been measured and no clear correlation was found between the activation energy for the formation of the industrially important low-resistance C54-TiSi2 phase and its formation temperature. It is also demonstrated that with certain moderate doping levels typical of complementary metal-oxide-semiconductor manufacturing, boron or phosphorus-doped polycrystalline silicon can delay the formation of C54-TiSi2 more than arsenic-doped polycrystalline silicon. Finally, by using in situ resistance measurements, it is demonstrated that the "two-step'' thermal annealing process similar to a salicide process requires less thermal annealing time at high temperatures to form C54-TiSi2 than a single "one-step'' thermal anneal at the same temperature. © 1994 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1520-4995
    Source: ACS Legacy Archives
    Topics: Biology , Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 64 (1993), S. 2947-2951 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A fast-response chromel-alumel (and chromel-constantan) microthermocouple is described and its dynamic characteristics are measured. The microthermocouple features a microdisk junction 0.08 mm in diameter and 2.5 μm thick. Its time constant in turbulent flow of liquid Refrigerant-113 (a poor heat conductor) is measured to be ∼4.6 ms. This time constant was reduced to ∼3.4 ms with a phase-lead compensation circuit. It was possible to distinguish between vapor and liquid phase temperatures in turbulent subcooled boiling flow of Refrigerant-113 with the compensated microthermocouple.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Physics of Fluids 13 (2001), S. 3089-3092 
    ISSN: 1089-7666
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A functional is presented for the stored energy content, or potential energy, of a nonuniform distribution of surfactant on a liquid interface. This is the energy available to drive fluid motion using surface-tension-gradient forces. The functional is shown to be non-negative. An energy evolution equation is derived for the motion of a thin liquid film, whose shape evolves under the combined influence of surface tension, viscous, and surfactant effects. Numerical calculations show the time history of these global energy components. Results are relevant to the flow behavior of wetting agents, soap films, foams, and emulsions with possible applications in the industrial and biological worlds. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Physics of Fluids 12 (2000), S. 1278-1295 
    ISSN: 1089-7666
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A theoretical and numerical model is formulated to describe the instability and the long-time evolution of both gravity-driven and surface-shear-stress-driven thin coating films. A single evolution equation, of higher-order diffusive type, models the flow for either problem. It is derived using the lubrication approximation. For partially wetting systems, the effect of finite contact angle is incorporated in the equation using a particular disjoining pressure model. The base state, in each case, is a two-dimensional steadily propagating capillary front. Slight perturbations of the base state, applied along the front, initiate the fingering instability. Early-time results accurately reproduce the wavelengths of fastest growth and the corresponding eigenmodes as reported in published linear stability analyses. As time proceeds, depending on parameter values, various fingering patterns arise. For conditions of perfect wetting with the substrate downstream of the moving front covered with a thin precursor layer, predicted nonlinear finger evolution agrees well with published experiments. The ultimate pattern, in this case, is a steadily translating pattern of wedge-shaped fingers. Alternatively, for partially wetting systems that exhibit sufficiently large static contact angles, long straight-sided fingers or rivulets are formed. Finally, for larger contact angles, or at relatively low speeds, we predict that the flowing rivulets will become unstable and break up into strings of isolated droplets. © 2000 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 61 (1990), S. 2462-2465 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A UHF/microwave technique that measures the wave propagation velocity along a modified microstrip line to determine the thickness of an adjacent film of water (up to about 1 mm) on a metallic surface is described. The technique may be extendable to the measurement of the thickness of coatings on both metallic and nonmetallic surfaces.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Journal of chemical & engineering data 12 (1967), S. 584-586 
    ISSN: 1520-5134
    Source: ACS Legacy Archives
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Biochemistry 33 (1994), S. 15131-15140 
    ISSN: 1520-4995
    Source: ACS Legacy Archives
    Topics: Biology , Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    s.l. : American Chemical Society
    Biochemistry 33 (1994), S. 14815-14824 
    ISSN: 1520-4995
    Source: ACS Legacy Archives
    Topics: Biology , Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Publishing Ltd
    Journal of the American Water Resources Association 29 (1993), S. 0 
    ISSN: 1752-1688
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Architecture, Civil Engineering, Surveying , Geography
    Notes: : The on-farm economic effectiveness of government capital grants, subsidized interest rates, and the Canadian Wheat Board (CWB) delivery quota levels in terms of adoption and/or expansion of irrigation in Saskatchewan is tested. The annualized net income at 5 and 20 years of three representative farm types - a dryland grain farm, an irrigated grain farm, and an irrigated mixed farm - are used in the analysis. Tradeoffs between income levels and the risks associated with adoption/expansion of irrigation are evaluated using mean-standard deviation tradeoff and stochastic dominance. Risk differences arise due to reduced business risk through higher yields and increased financial risk through higher borrowing when adopting or expanding irrigation. Capital grants and subsidized interest rates are effective policy measures for dryland grain farms adopting irrigation because the farms are left in a similar risk position. However, these grants and interest rates are not effective policy measures in the medium run (5 years) for irrigated grain farms expanding irrigation because they lower the farm's risk efficiency. In the long run (20 years), the capital grants and subsidized interest rates need to be combined with open CWB delivery quotas before the risk position can be improved for irrigated grain farms expanding irrigation. Finally, the grants and interest rates need to be combined with increased irrigated hay production for risk efficiency to increase in both the medium and long run (5 and 20 years, respectively) on irrigated mixed farms expanding irrigation.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...