Bibliothek

feed icon rss

Ihre E-Mail wurde erfolgreich gesendet. Bitte prüfen Sie Ihren Maileingang.

Leider ist ein Fehler beim E-Mail-Versand aufgetreten. Bitte versuchen Sie es erneut.

Vorgang fortführen?

Exportieren
Filter
  • Engineering General  (2)
  • Diffusion, MIEC  (1)
  • Key words Intestinal lipoproteins, Sf 〉400 fraction, Sf 20–400 fraction, insulin resistance, insulin suppression test, steady-state plasma glucose, steady-state plasma insulin.  (1)
  • Micromechanical modeling  (1)
Materialart
Erscheinungszeitraum
Schlagwörter
  • 1
    Digitale Medien
    Digitale Medien
    Amsterdam : Elsevier
    Solid State Ionics 74 (1994), S. 75-84 
    ISSN: 0167-2738
    Schlagwort(e): Diffusion, MIEC ; Oxygen membranes ; Porous electrodes ; surface exchange
    Quelle: Elsevier Journal Backfiles on ScienceDirect 1907 - 2002
    Thema: Physik
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 2
    Digitale Medien
    Digitale Medien
    Springer
    Diabetologia 37 (1994), S. 781-787 
    ISSN: 1432-0428
    Schlagwort(e): Key words Intestinal lipoproteins, Sf 〉400 fraction, Sf 20–400 fraction, insulin resistance, insulin suppression test, steady-state plasma glucose, steady-state plasma insulin.
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Medizin
    Notizen: Summary The primary goal of the present study was to examine the effects of improved glycaemic control associated with glipizide treatment on postprandial lipaemia in non-insulin-dependent diabetic patients. The metabolism of triglyceride-rich lipoproteins of intestinal origin was assessed by measuring the retinyl palmitate content in plasma and the Svedberg flotation index (Sf) 〉400 and Sf 20–400 lipoprotein fractions. Fasting plasma glucose concentrations (14.5±0.5 vs 9.0±0.5 mmol/l), glycated haemoglobin levels (13.1± 0.6 vs 9.7±0.6 %), and daylong plasma glucose concentrations were all significantly lower after glipizide treatment (p〈0.001). The improvement in glycaemic control was associated with increases in insulin-mediated glucose uptake (p〈0.001) and plasma post-heparin lipoprotein and hepatic lipolytic activities (p〈0.02). Both fasting plasma triglyceride (3.09±0.51 vs 2.37± 0.34 mmol/l), and postprandial triglyceride concentrations (p〈0.05–0.001) were lower following glipizide treatment, associated with a significant fall in retinyl palmitate content in all three lipoprotein fractions (p〈0.02–0.001), with the most substantial decrease seen in the Sf 20–400 fraction. These data indicate that glipizide-induced improvement in glycaemic control was associated with changes in the metabolism of triglyceride-rich lipoproteins of intestinal origin that would be anticipated to reduce risk of coronary heart disease in non-insulin-dependent diabetic patients. [Diabetologia (1994) 37: 783–787]
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 3
    Digitale Medien
    Digitale Medien
    Springer
    International journal of fracture 101 (2000), S. 161-180 
    ISSN: 1573-2673
    Schlagwort(e): Micromechanical modeling ; cohesive force ; fracture ; heterogeneous materials ; elasticity ; fracture modes ; failure modes ; numerical simulation ; crack propagation ; ceramic composites.
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract A micromechanical model that provides explicit accounts for arbitrary microstructures and arbitrary fracture patterns is developed and used. The approach uses both a constitutive law for the bulk solid constituents and a constitutive law for fracture surfaces. The model is based on a cohesive surface formulation of Xu and Needleman and represents a phenomenological characterization for atomic forces on potential crack/microcrack surfaces. This framework of analysis does not require the use of continuum fracture criteria which assume, for example, the existence of K-fields. Numerical analyses carried out concern failure in the forms of crack propagation and microcrack formation. Actual microstructures of brittle alumina/titanium diboride (Al2O3/TiB2) composites are used. The results demonstrate the effects of microstructure and material inhomogeneities on the selection of failure modes in this material system. For example, the strength of interfaces between the phases is found to significantly influence the failure characteristics. When weak interfacial strength exists, interfacial debonding and microcrack initiation and growth are the principal mode of failure. When strong interfacial strength is derived from material processing, advancement of a dominant crack and crack branching are observed.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 4
    Digitale Medien
    Digitale Medien
    Chichester [u.a.] : Wiley-Blackwell
    International Journal for Numerical Methods in Engineering 29 (1990), S. 1681-1699 
    ISSN: 0029-5981
    Schlagwort(e): Engineering ; Engineering General
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Mathematik , Technik allgemein
    Notizen: A new concept for complex structural optimization problems is presented. Based on investigation of the mechanical nature of the studied problem, a set of basic mechanical characteristics can be introduced as the generalized variables. A high-quality explicit first-level approximate problem FA is formed by first-order Taylor series expansion of the behaviour constraints in terms of the generalized variables. The FA is explicit but highly non-linear with respect to design variables. Therefore, a second-level approximation is introduced to solve the FA by considering a sequence of second-level approximate problems SA in the design variable space. This approach is a Two-Level Approximation Concept. Its application to space frame synthesis shows its good grasp of the mechanical nature of the problem. The computational results for several examples show that the method presented in this paper is very efficient.
    Zusätzliches Material: 5 Ill.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 5
    Digitale Medien
    Digitale Medien
    Chichester : Wiley-Blackwell
    International Journal for Numerical Methods in Fluids 22 (1996), S. 283-296 
    ISSN: 0271-2091
    Schlagwort(e): laminar flow ; numerical modelling ; particle image velocimetry measurement ; rotating disc ; Engineering ; Engineering General
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Maschinenbau
    Notizen: The fluid flow field within an enclosed cylindrical chamber with a rotating flat disc was calculated using a finite volume computational fluid dynamics (CFD) model and compared with particle image velocimetry (PIV) measurements. Two particular laminar cases near the Transitional flow regime were investigated: Reynolds number Re=2.5×1 4, chamber aspect ratio G (h/Rd)=0.2 and Re=4.2×104, G (h/Rd)=0.217. This enabled direct comparison with the numerical and experimental results reported by other researchers. The computational details and some major factors that affect the computed accuracy and convergence speed are also discussed in detail. PIV results containing some 4300 velocity vector points in each of seven planes for each case were obtained from the flow field parallel to the rotating disc. It was found that PIV results could be obtained in planes within the boundary layers as well as the core flow by careful use of a thin laser illumination sheet and correct choice of laser pulse separation. There was close agreement between numerical results, the present PIV measurements and other reported experimental and numerical results.
    Zusätzliches Material: 10 Ill.
    Materialart: Digitale Medien
    Bibliothek Standort Signatur Band/Heft/Jahr Verfügbarkeit
    BibTip Andere fanden auch interessant ...
Schließen ⊗
Diese Webseite nutzt Cookies und das Analyse-Tool Matomo. Weitere Informationen finden Sie hier...