Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 1432-0630
    Keywords: 78.55.Cr ; 78.30.Gt ; 81.20.-n
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Abstract Mg+ ions were implanted into highly pure InP grown by the liquid encapsulated Czochralski (LEC) method in which the Mg concentration [Mg] was varied between 1×1015 cm−3 and 3×1020 cm–3. Two annealing methods were used: furnace annealing (FA) up to 740° C and flash lamp annealing (rapid thermal annealing, RTA) up to 900° C. For characterization, photoluminescence (PL) spectra were measured between 2K and room temperature together with Raman scattering measurements at room temperature. An emission designated by g, which was attributed to a novel energy state of an isolated acceptor, was found to be produced for a rather low value of [Mg]. In addition, a broad emission denoted by [g−g], which was ascribed to acceptor-acceptor pairs, was observed below bound exciton emissions for moderate values of [Mg]. These features were quite similar to those previously observed in acceptor-doped GaAs when the background concentration of donors is extremely low. Two additional novel emissions located far below the band-to-acceptor emission were also obtained, and each showed a remarkable energy shift towards lower energy with increasing [Mg]. The binding energies of these emissions were estimated from the temperature dependence of PL spectra and the results suggest that they are complex-type radiative recombination centers, presumably donor-acceptor-type centers. A strong broad emission centered near the band-to-acceptor emission was observed for [Mg]=3×1020 cm−3. This observation indicates a formation of a new material between In, P and Mg, which was also attested by the appearance of a new TO-like Raman signal for [Mg] greater than 1×1019 cm−3. A substantial difference of PL and Raman spectra was revealed for the two annealing methods, suggesting that the annealing behaviour of ion-implanted InP should be investigated more extensively in order to establish reliable annealing procedures.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 0887-624X
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: In order to clarify the general kinetic behavior of emulsion polymerization initiated by oilsoluble initiators, the emulsion polymerization of styrene initiated by 2,2′-azoisobutyronitrile was as a typical example, investigated thoroughly. The variations of the polymerization rate and the number of polymer particles produced with changes in emulsifier (sodium lauryl sulfate), initiator, and monomer concentrations initially charged and the reaction temperature were determined. It is shown from these experimental results that the kinetic behavior of this emulsion polymerization system is quite similar to that of styrene emulsion polymerization initiated by the water-soluble initiator, potassium persulfate despite the difference in the principal loci of radical production in both systems.
    Additional Material: 14 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    Journal of Biomedical Materials Research 14 (1980), S. 557-566 
    ISSN: 0021-9304
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Medicine , Technology
    Notes: The mechanical properties of the hydrogel membrane of poly(methyl methacrylate-N-vinylpyrrolidone) were studied for the purpose of making soft contact lenses for extended wear. The dependence of tensile fracture energy, flexibility, and recovery from deformation on the water content and thickness of the hydrogel membrane was studied. Reducing the thickness of a lens was found to exert a more advantageous effect than increasing its water content on maximizing the tensile fracture energy under the condition of an adequate supply of oxygen to the cornea through the contact lens. As long as its water content is controlled between 63 and 78%, the contact lens made of poly(methyl methacrylate-N-vinylpyrrolidone) has the flexibility on the same order as that of conventional soft contact lenses of poly(2-hydroxyethyl methacrylate). The rate of recovery from deformation increases with water content, and the residual elongation is negligible in the range of water content over about 70%. It is concluded that practical requirements for use of these contact lenses, determined by these three mechanical properties, can be satisfied at the same time if the water content of the contact lens is adjusted at about 70%.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science: Polymer Letters Edition 19 (1981), S. 143-147 
    ISSN: 0360-6384
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...