Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 64 (1988), S. 5732-5734 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Fe-Cr-Co magnets with radial anisotropy were developed by rotating samples in a magnetic aging furnace. The anisotropy is altered by the applied magnetic field strength. The Fe-25 wt. %Cr-12 wt. %Co-0.5 wt. %Ti alloy aged in a magnetic field of 100 Oe yields the magnetic properties of (BH)max=24 kJ m−3 (3 MGOe) and iHc=48 kA m−1 (600 Oe) parallel to radial direction, which are higher than those of (BH)max=7 kJ m−3 (0.9 MGOe), iHc=33 kA m−1, measured parallel to the circumferential direction. The increment of the applied magnetic field over 200 Oe alters the radial anisotropy into a circumferential one. Microstructural studies indicate that the iron-rich phase is elongated parallel to the direction of induced anisotropy. Computations of the magnetic flux distribution in disk samples confirm the experimental observations.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 63 (1988), S. 3707-3709 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Present works describe the development of Fe-Cr-Co-Mo alloys with favorable {110}〈100〉 texture, which will lie along the transverse direction (TD) of the rolled strips. The studied alloy composition is Fe-30 wt. % Cr-15 wt. %Co-3 wt. % Mo-0.1 wt. % Mn-0.05 wt. % S. The magnetic properties of the alloys have been enhanced along the TD and the best magnetic properties obtained with TD alloys are Br=1.2 T (12.0 kG), iHc=82 kA m−1 (1025 Oe), and BHmax=56 kJ m−3 (7.0 MGOe). The favorable texture is developed by secondary recrystallization, caused by a mixture of rolling and annealing. It can be considered that the process adopted in this investigation is useful for mass production of Fe-Cr-Co alloys with high energy products, without forming a columnar structure or a single crystal.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 57 (1985), S. 4146-4148 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Present works describe the developments the low cost R-Fe-B sintered permanent magnets. Three different didymiums are chosen for the low cost mixtures of rare-earth elements. The studied alloy compositions are Fe-(32.5–34.5)wt. %R-(1–1.6)wt. %B, where R elements are didymium (Nd-10wt. %Pr), 5Ce-didymium (Nd-15%Pr-5%Ce), and 40 Ce-didymium (Nd-10%Pr-40%Ce). The specimens were prepared by the conventional powder metallurgical techniques. The best magnetic properties obtained in this studies are Br=13.2 kG, iHc=10.2 kOe, and (BH)max=40 MGOe with the Fe-33.5% (5Ce-didymium)-1%B alloy. Temperature dependence of iHc of this alloy is almost comparable to that of the Nd-Fe-B alloys.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 57 (1985), S. 4167-4169 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Fe-Cr-Co ductile alloys produce magnetic properties comparable to those of Alnico permanent magnets family, up to (BH)max=91.2 kJ/m3(11.4 MGOe). It is technologically known that the addition of Ti to the Fe-Cr-Co alloys extends the α-phase region of system and improves the magnetic properties. The purpose of this work is to study the effect of Ti on microstructures and magnetic properties of Fe-Cr-Co alloys. The microstructures of Fe-25 wt.% Cr-12 wt.% Co alloys with or without Ti melted in air or in vacuum, were studied by optical microscopy, electron probe microanalysis (EPMA), and transmission electron microscopy (TEM). The alloys without Ti exhibit the precipitates of Cr23C6 carbide and Cr2N nitride a along the grain boundary or inside grain. These carbides and nitrides form the Cr-depleted zone around them. However, the addition of Ti suppressed the formation of Cr-depleted zone, in forming the Ti(C,N), and the magnetic properties are improved.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 57 (1985), S. 4252-4254 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The effective permeability ( μeff) of the ring Sendust alloys (Fe-9–10 wt. % Si-5–7 wt. %Al), molded with Epoxy resin, was measured in the temperature range of −10 to 70 °C. The μeff of the alloys in molded condition measured at 20 °C is smaller than that in unmolded condition. The high values of the μeff at 20 °C of the molded alloys were obtained from the alloys in which magnetostriction constants (λs) were close to zero. The temperature dependencies of the μeff for the studied alloys in the unmolded condition are very similar, but after molding they are classified into four variations depending on the value of λs. When the alloys have large positive or negative values of λs, the μeff increases or decreases monotonically with increasing temperatures, but for the alloy with λs (approximately-equal-to)0, the μeff temperature dependence is complex. These behaviors of the μeff with temperature are interpreted on the basis of the induced stress, initiating from the differences in thermal expansion between alloys and Epoxy resin. The μeff of the molded alloys was mainly dominated by the induced uniaxial magnetic anisotropy (Ku) by the tangential and axial compressive stresses in the molded ring alloys.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 64 (1988), S. 5902-5904 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The superconducting behavior of (Y1−xLax)Ba2Cu3Oy compounds for 0≤x≤1 was studied. It was found that Tc decreased with increasing La content. (Y1−xLax)Ba2Cu3Oy for 0≤x≤0.4, fired at 1050 °C in air, shows onset temperatures above 90 K. Annealing (Y1−xLax)Ba2Cu3Oy at 300 °C in O2 enhanced the onset temperature above 70 K for all studied compositions (x=0–1), and altered the crystal structure from tetragonal to orthorhombic.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Publishing Ltd
    Annals of the New York Academy of Sciences 553 (1989), S. 0 
    ISSN: 1749-6632
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Natural Sciences in General
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Springer
    Neuroradiology 30 (1988), S. 31-34 
    ISSN: 1432-1920
    Keywords: Cerebral paragonimiasis ; Computed tomography ; Intracranial calcification
    Source: Springer Online Journal Archives 1860-2000
    Topics: Medicine
    Notes: Summary The CT findings in 5 patients with cerebral paragonimiasis in the chronic state are presented. The findings were: 1) multiple, densely calcified areas with a variety of round or nodular shapes in the brain, 2) a large low density area surrounding or connecting with the calcified areas, and 3) cortical atrophy and ventricular dilatation. The relation between the CT findings and the previously reported plain skull X-ray findings or neuropathological findings are discussed.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Oxford [u.a.] : International Union of Crystallography (IUCr)
    Acta crystallographica 45 (1989), S. 1902-1904 
    ISSN: 1600-5759
    Source: Crystallography Journals Online : IUCR Backfile Archive 1948-2001
    Topics: Chemistry and Pharmacology , Geosciences , Physics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract A new-type redox battery has been developed. Some ruthenium complexes in organic electrolyte solution were utilized as the electrode active materials. A single cell consisting of [Ru(bpy)3]2+ complex in acetonitrile solution had an open circuit voltage of 2.6 V and a discharge current of 5 mA cm−2 (at a smooth carbon electrode). The characteristics of this type of cell were much influenced by such factors as the diaphragm material and the concentration of the complex. A cell with flowing electrolyte was also constructed and its charge-discharge performance was examined.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...