Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 21 (1975), S. 985-996 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The penetration of drugs and other micromolecules through intact human skin can be regarded as a process of dissolution and molecular diffusion through a composite, multilayer membrane, whose principal barrier to transport is localized within the stratum corneum. A mathematical model of the stratum corneum as a two-phase protein-lipid heterogeneous membrane (in which the lipid phase is continuous) correlates the permeability of the membrane to a specific penetrant with the water solubility of the penetrant and with its lipid-protein partition coefficient.Experimentally measured permeabilities of human skin to a variety of drugs have been found to conform to this model. The extraordinarily low permeability of skin to most micromolecules appears to arise from the very low diffusivity of such molecules in the intercellular lipid phase.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 22 (1976), S. 828-832 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The sorption and rate of permeation of scopolamine base in human skin have been measured as a function of drug concentration in aqueous solution contacting the stratum corneum surface of the skin. The sorption isotherm is nonlinear, and the apparent penetrant diffusivity computed from steady state permeation data is greater than that estimated from unsteady state (time lag) measurements.By assuming that sorption occurs by both ordinary dissolution and binding of penetrant to immobile sites in the membrane, the experimental sorption isotherm can be predicted, and the disparity between steady state and time lag diffusivities can be reconciled.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 7 (1969), S. 753-762 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Eight epoxy-diamine networks have been formed, diamines with 2 to 12 methylene groups being used as curing agents. Dynamic mechanical tests revealed four transition regions in the dynamic loss modulus/temperature relationship. Two possible explanations for the relaxation of the glycidyl portion of the structure are proposed. One of the relaxations could be due to the breakdown of hydrogen bonds through the hydroxyl and ether groups. The second could be ascribed to the relaxation of the unbonded glycidyl groups or a second relaxation of the glycidyl groups after the breakdown of the hydrogen bonds.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 23 (1983), S. 1054-1058 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Linear polymers of silicone gums (polysiloxanes) have many attributes that make them attractive for lithographic applications, such as oxidative and thermal stability, good adhesion properties, solubility in common solvents, and resistance to etching in an oxygen plasma. When polysiloxanes are used as the top imaging layer (∼2000Å) in a two-layer resist system, the developed negative siloxane images act as a high resolution etch mask for the oxygen plasma etching of the bottom planarizing polymer layer. Commercially available polysiloxanes have been evaluated for their deep UV sensitivity at 2537Å, and have been found to have very high resolution capabilities (∼0.5μ) and high contrast (γ = 4). The negative images do not swell in the developer, and the line width is therefore independent of development time. The combination of high resolution, sensitivity, and ease of processing make this a simple multilayer system for deep UV and e-beam applications.
    Additional Material: 11 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 23 (1983), S. 1047-1049 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: PCS(poly-4-chlorostyrene) has previously been evaluated as a negative e-beam resist, but although the sensitivity was good [2 to 5μC/square centimeter (cm2)], the contrast (γ) was poor (1.1 to 1.5). Recent experiments have shown that contrast is not only a function of molecular weight distribution (MWD), but can also be affected by polymerization conditios. Among these are: branching, head to head linkages, and oxygen in backbone. PCS was prepared via thermal free radical solution polymerization, and then fractionated by differential solvation techniques. Reactions occurring during polymerization and crosslink formation on irradiation will be discussed. For molecular weights of 700 and 300K respectively (same MWD), the sensitivity was 2 and 5μC/cm2, while the contrast (γ) was 3.5 for both. This is the highest reported contrast for a polymeric negative resist. The resist can then be UV hardened after development, and will not flow at 200°C. The RIE etch rate is ∼1/2 that of PMMA in various plasmas.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 29 (1989), S. 907-910 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: A negative resist based upon photo-acid initiated cationic polymerization of an epoxy resin (1, 2) was reported in the early eighties with the advent of onium salts (3-5). An efficient acid generating onium salt, triphenylsulfonium hexafluoroantimonate (6), absorbs light in the deep UV producing acid upon direct photolysis in this region of the spectrum. The resin component of such a negative resist system must be optically transparent over the exposure wavelengths to obtain vertical image profiles. Another difficulty often encountered with crosslinking negative resists is swelling of the crosslinked matrix during development with organic solvents. This swelling manifests itself in distorted images and/or complete adhesion loss, especially when submicron features are involved. Our goal has been to address these problems and develop an organic developable deep UV resist capable of providing submicron images. Optically transparent commercial resins, styrene-allyl alcohol copolymers, have been converted to glycidyl ethers, thereby providing cationically polymerizable functionalities. Careful choice of the resin was made to obtain reactive ion etch resistance, thermal stability, good adhesion, and coating properties. The synthetic procedure and characterization of the epoxy resin will be presented. The effect of the molecular weight distribution upon swelling during development and general solubility properties also will be discussed. Resist formulations exhibited sensitivities of 19 to 30 mJ/cm2 on a Perkin Elmer 500 in the deep UV (UV2) mode. The electron beam sensitivity is 3 to 5 μC/cm2 at 20 KeV. Submicron images have been generated in both optical and electron beam lithography.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-1: Polymer Chemistry 6 (1968), S. 449-458 
    ISSN: 0449-296X
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Notes: Infrared spectroscopy was empolyed to study the nature of the structural changes which occurred through oxidation during the emulsion polymerization of styrene. Aliphatic carboxylic, amino, and phosphate emulsifiers and hydrogen peroxide and potassium persulfate initiators were empolyed for polymer preparation. In addition, a polystyrene dispersion prepared in the absence of any emulsifier or stabilizer was examined. Irrespective of the nature of the initiator-emulsifier combination employed, all of the polymer spectra revealed bands at 1705 and 1770 cm.-1. The band at 1705 cm.-1 was assigned in part to the carbonyl stretching mode of dimertic carboxylic acid, formed by oxidation, in the polystyrene chains. Absorption at 1770 cm.-1, which was very weak, was tentatively attributed to the carbonyl stretching mode of the monomeric form of this acid. The structure of the acid endgroup was not established, but the results obtained suggest that it was possibly a phenylacetic acid residue or a residue with a similar structure.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...