Library

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Science, Ltd
    Journal of metamorphic geology 20 (2002), S. 0 
    ISSN: 1525-1314
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Geosciences
    Notes: Nine marble horizons from the granulite facies terrane of southern India were examined in detail for stable carbon and oxygen isotopes in calcite and carbon isotopes in graphite. The marbles in Trivandrum Block show coupled lowering of δ13C and δ18O values in calcite and heterogeneous single crystal δ13C values (− 1 to − 10‰) for graphite indicating varying carbon isotope fractionation between calcite and graphite, despite the granulite facies regional metamorphic conditions. The stable isotope patterns suggest alteration of δ13C and δ18O values in marbles by infiltration of low δ13C–δ18O-bearing fluids, the extent of alteration being a direct function of the fluid-rock ratio. The carbon isotope zonation preserved in graphite suggests that the graphite crystals precipitated/recrystallized in the presence of an externally derived CO2-rich fluid, and that the infiltration had occurred under high temperature and low fO2 conditions during metamorphism. The onset of graphite precipitation resulted in a depletion of the carbon isotope values of the remaining fluid+calcite carbon reservoir, following a Rayleigh-type distillation process within fluid-rich pockets/pathways in marbles resulting in the observed zonation. The results suggest that calcite–graphite thermometry cannot be applied in marbles that are affected by external carbonic fluid infiltration. However, marble horizons in the Madurai Block, where the effect of fluid infiltration is not detected, record clear imprints of ultrahigh temperature metamorphism (800–1000 °C), with fractionations reaching 〈2‰. Zonation studies on graphite show a nominal rimward lowering δ13C on the order of 1 to 2‰. The zonation carries the imprint of fluid deficient/absent UHT metamorphism. Commonly, calculated core temperatures are  〉 1000 °C and would be consistent with UHT metamorphism.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Science Inc
    Journal of metamorphic geology 19 (2001), S. 0 
    ISSN: 1525-1314
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Geosciences
    Notes: An extensive humite-bearing marble horizon within a supracrustal sequence at Ambasamudram, southern India, was studied using petrological and stable isotopic techniques to define its metamorphic history and fluid characteristics. At peak metamorphic temperatures of 775±73°C, based on calcite-graphite carbon isotope thermometry, the mineral assemblages suggest layer-by-layer control of fluid compositions. Clinohumite + calcite-bearing assemblages suggest XCO2 〈 0.4 (at 700°C and 5 kbar), calcite + forsterite + K-feldspar-bearing assemblages suggest XCO2〉0.9 (at 790°C); and local wollastonite + scapolite + grossular-bearing zones formed at XCO2 of c. 0.3. Retrograde reaction textures such as scapolite + quartz symplectites after feldspar and calcite and replacement of dolomite + diopside or tremolite+dolomite after calcite+forsterite or calcite+clinohumite are indicative of retrogression under high XCO2 conditions. Calcite preserves late Proterozoic carbon and oxygen isotopic signatures and the marble lacks evidence for extensive retrograde fluid infiltration, while during prograde metamorphism the possible infiltration of aqueous fluids did not produce significant isotopic resetting. Isotopic zonation of calcite and graphite grains was likely produced by localized CO2 fluid infiltration during retrogression. Contrary to the widespread occurrence of humite-marbles related to retrograde aqueous fluid infiltration, the Ambasamudram humite-marbles record a prograde-to-peak metamorphic humite formation and retrogression under conditions of low XH2O.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 55 (1989), S. 723-725 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A significant improvement in the maximum output power of a 1.3 μm GaInAsP/InP laser with a semi-insulating current confinement structure is reported. The improvement has been achieved by interposing an n-type InP layer between a p-InP substrate and an Fe-doped InP layer. A maximum cw output power of 180 mW and a modulation bandwidth of 8.5 GHz have been obtained.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 54 (1989), S. 1077-1079 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A maximum cw power of 90 mW at 25 °C was obtained for a GaInAsP/InP laser with a semi-insulating InP current blocking layer grown by metalorganic vapor phase epitaxy on a p-type InP substrate, a 700-μm-long cavity, and an antireflection coating on the front facet. The 3 dB bandwidth was in excess of 6 GHz with a low parasitic capacitance of 15 pF despite the long cavity. The semi-insulating layer with the resistivity of 5×107 Ω cm was formed by doping only Fe. The current blocking characteristics of the blocking layer with the same configuration as the lasers were examined under various temperatures.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 65 (1989), S. 4445-4447 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Critical temperatures Tc and critical currents Ic under uniaxial tensile loading have been studied on multifilamentary Nb3Al wires fabricated by a newly developed composite diffusion process. Both Tc and Ic are monotonically decreased with applied strain, showing reversible behavior up to fracture strains of the wires at about 1.3%. These characteristics may be attributed to the composite wire structure, namely to the small difference in thermal contraction between the niobium matrix and the Nb3Al filaments, as well as to the extremely small sizes of the Nb3Al filaments.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Palo Alto, Calif. : Annual Reviews
    Annual Review of Biophysics and Biomolecular Structure 23 (1994), S. 87-114 
    ISSN: 1056-8700
    Source: Annual Reviews Electronic Back Volume Collection 1932-2001ff
    Topics: Biology , Physics
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 59 (1991), S. 2965-2967 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A wire-conductor fabrication method has been developed for Cu–Ag alloys containing 2–60 at. % Ag where high strength and high conductivity conductors are obtained by cold working combined with intermediate heat treatment. The intermediate heat treatment is repeated 3–4 times at 350–450 °C for 1–2 h at appropriate stages of reduction of area. The optimized Cu-16 at. % Ag alloy wire with 99% reduction of area showed a tensile strength of 1000 MPa and an electrical conductivity of 80% IACS at room temperature. This suggests that the wires fabricated may be very promising for high-field pulsed magnet use.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 71 (1997), S. 122-124 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Strain effects on critical current densities have been examined for conductors containing nearly stoichiometric Nb3Al filaments with fine grains. The Nb3Al phase in these multifilamentary conductors are prepared by phase transformation from supersaturated Nb(Al) bcc solid solution and show high-field critical current densities much larger than those for conventionally prepared Nb3Al conductors, where the Nb3Al phase is known to be off-stoichiometric. The degradation of critical current densities with −0.7% intrinsic strain is ca. 20% at 12 T, comparable with those for conventional Nb3Al conductors of high strain tolerance. © 1997 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 69 (1996), S. 677-678 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have found the effects of HgTe layers on dislocations of (111)B HgCdTe layers grown on Si substrates by metalorganic vapor phase epitaxy. The dislocations in HgCdTe layers were reduced by inserting thin HgTe layers between HgCdTe and CdTe buffer layers. Using this method, the dislocation density of 2.3×106 cm−2 was obtained, which is less than quarter that of HgCdTe layers without HgTe. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 69 (1996), S. 2876-2878 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: CdTe(1¯ 1¯ 3¯)B epilayers were grown on Si substrates oriented (112)5° off toward the [1¯ 1¯ 1] direction by molecular beam epitaxy (MBE). A Zn irradiation process was developed in order to obtain a (1¯ 1¯ 3¯)B face. HgCdTe(1¯ 1¯ 3¯)B epilayers were grown on 20 μm-thick CdTe/Si(112) 5° off, and characterized. These layers have double-crystal x-ray rocking curves with full width at half-maximum as low as 64 arc s, and etch pit densities of 4.4×106 cm−2 and 2.6×105 cm−2 for as-grown and thermal-cycle annealed films, respectively. Photodiodes were also fabricated to demonstrate the capability of large-area MBE-HgCdTe/Si focal-plane arrays. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...