Library

Language
Preferred search index
Number of Hits per Page
Default Sort Criterion
Default Sort Ordering
Size of Search History
Default Email Address
Default Export Format
Default Export Encoding
Facet list arrangement
Maximum number of values per filter
Auto Completion
Feed Format
Maximum Number of Items per Feed
feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 73 (1993), S. 6609-6611 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Recently a heat-proof magnetic domain refining technique has been developed which is characterized by the introduction of grooves on a surface of steel sheet after final cold rolling. In this paper, magnetic properties and the domain refining effect of grooving are investigated. A grooving process is constituted by resist printing on the surface of steel sheets after final cold rolling and succeeding electrolytic etching. The grooves were introduced almost perpendicular to the rolling direction of steel sheets. The width and depth of each grove are about 200 and 20 μm, respectively. With this newly developed method, about 10% reduction in iron loss was achieved and less than 0.34 W/lb at 1.5 T, 60 Hz was obtained. Using this new material, the iron loss of wound core transformers can be reduced by about 10% as compared with nongrooved material. Domain width was dramatically reduced by grooving, which caused the reduction of eddy current loss. This reduction is considered to be caused by the demagnetizing field effect due to free poles in the vicinity of grooves. It was clarified that in grooved sheets the magnetization on the ungrooved surfaces proceeded faster than on the grooved surfaces and therefore, hysteresis loss and magnetizing characteristics did not deteriorate by grooving.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 75 (1994), S. 8204-8206 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The recombination kinetics of the electron-hole plasma in strongly excited, undoped Ga0.5In0.5P are investigated at 300 and 150 K by time-resolved photoluminescence measurements using line-shape analysis of transient spectra. Radiative recombination dominates, and no influence of the Auger effect is observed up to our highest carrier concentration of 1.5×1019 cm−3. Random alloy and ordered samples have the same recombination rate. The radiative recombination coefficients are found to be (1.0±0.3)×10−10 and (4±1)×10−10 cm3 s−1 at 300 and 150 K, respectively. An upper limit for the Auger coefficient is 3×10−30 cm6 s−1 at 300 K.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The molecular-beam-epitaxial growth of InxGa1−xAs on GaAs or AlyGa1−yAs leads to a variation of In content with depth, due to In segregation. However, by predepositing In at the beginning of InxGa1−xAs growth, and also thermally removing the excess In at the end, we can produce a layer with the ideal "square'' In profile. We find that the performance of AlyGa1−yAs/InxGa1−xAs/GaAs high electron mobility transistors is most enhanced by the predeposition step alone. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 76 (1994), S. 2621-2626 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Based on two different experiments and an optical field calculation, we show that the free-carrier absorption αfc in Zn(Cd)Se/ZnMgSSe semiconductor lasers is about 4 cm−1 and that it is smaller than that of GaAs/AlGaAs semiconductor lasers. We have measured the dependence of the L-I characteristics on the cavity length of double heterostructure (DH) lasers under photopumped operation and of single quantum well-separate confinement heterostructure (SQW-SCH) lasers under current-injected operation. For the DH laser, the total absorption coefficient αi and β×J0 product (β is a gain constant, and J0 is the nominal current density that makes the gain equal to zero) are estimated to be 4.2 cm−1 and 8.6×10 cm−1, respectively. For the SQW-SCH laser, αi, β, and J0 are estimated to be 21 cm−1, 4.23×10−3 cm×μm/A, and 1.9×10−3 A/(cm2×μm), respectively. By calculating the optical fields of these lasers, we have estimated that the absorption in a GaAs substrate is 16.53 cm−1 in the SQW-SCH laser and that it is negligible in the DH laser. We have shown that the large loss in the SQW-SCH laser is caused by both αfc and the absorption in the substrate and that αi in the DH laser is caused only by free carrier absorption.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 79 (1996), S. 6439-6439 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: It was reported that La3Co is an interesting superconductor which has a critical temperature Tc of 4.5 K. Pr3Co and Nd3Co are ferromagnetic materials, which have Curie temperatures of 10 and 25 K, respectively. It was claimed that their magnetic structures are associated with the canting moment reflected to the symmetry of their crystal structure. In this paper we present the results of the specific heat measurement in these compounds in the temperature range from 2 to 30 K by a standard adiabatic heat pulse method. Two phase transitions are observed at 8 and 25 K in Nd3Co. One of them at 25 K corresponds to the Curie temperature mentioned above. Another is the transition corresponds to the moment reorientation, which was observed in the thermomagnetic curves and electrical resistivity measurement. This results claim that the moments are canted in this compounds. Magnetic entropy reaches 90% of R ln 2 at 25 K. However, it increases above the Curie temperature because the crystalline electric field effects plays an important role in this compounds. There are two peaks of 10 and 12 K in Pr3Co. The above temperature corresponds the Curie temperature but another was unknown. Thus we performed the specific heat measurement for Pr7Co3, which is very close to the Pr3Co in the phase diagram. We could observe the phase transition at 12 K for Pr7Co3 in the specific heat measurement and electric resistivity measurement. It is clear that the phase transition at 12 K comes from impurity of Pr7Co3 in our Pr3Co compound. We prepare the good quality sample of Pr3Co and try to examine the specific heat measurement. © 1996 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 82 (1997), S. 2938-2943 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Surface morphological changes in ZnSe-related II–VI epitaxial films grown by molecular beam epitaxy have been investigated by atomic force microscopy and transmission electron microscopy. We found that under group-II-rich conditions with c(2×2) surface reconstruction, the process of roughening gives rise to periodic elongated corrugations aligned in the [11¯0] direction. Under group-VI-rich conditions with (2×1) surface reconstruction, rounded grains form instead of corrugated structures. The surface morphology is dependent on the VI/II ratio and growth temperature, but is independent of the film strain. The observed morphological changes are mainly due to growth kinetics and are not stress driven. We propose a model to explain the changes in surface morphology under group-II-rich conditions and group-VI-rich conditions. © 1997 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 51 (1987), S. 1572-1573 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A gain-guiding tapered stripe laser was fabricated using a Ga0.5In0.5P/(Al0.5Ga0.5)0.5In0.5P double heterostructure wafer grown by metalorganic chemical vapor deposition. The laser showed a continuous wave (cw) threshold current of 48 mA, a maximum temperature for cw operation of 81 °C, an aspect ratio of about 2, and an astigmatism near 25 μm. The emission wavelength was 684 nm. Thirty-two devices have been operating without significant degradation for more than 2000 h at 50 °C with a constant output power of 3 mW.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 66 (1995), S. 209-211 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have estimated the valence band discontinuity ΔEV at the p-ZnSe/p-ZnTe interface by means of electrical measurements. From capacitance-voltage measurement of a Schottky-like barrier at the heterojunction, ΔEV∼0.8 eV is found. The current-voltage characteristics of the junctions, however, suggest smaller values for ΔEV. The likely origin of this difference is leakage paths of the current in the barrier at the junction. © 1995 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 66 (1995), S. 2463-2465 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Efficient tunable ultraviolet generation by intracavity frequency doubling of a continuous wave Ti:sapphire laser was demonstrated. Maximum output is obtained of 460 mW at 398 nm corresponding to a total infrared-to-ultraviolet conversion efficiency over 70%. High conversion efficiency was resulted from a critically phase-matched, temperature-tuned lithium triborate crystal and a novel resonator design. The observed laser damage of the crystal coatings is also discussed. © 1995 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Woodbury, NY : American Institute of Physics (AIP)
    Applied Physics Letters 66 (1995), S. 1208-1210 
    ISSN: 1077-3118
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We have carried out structural studies of nonluminescent areas developed by current injection in ZnMgSSe alloy-based II–VI blue light emitting diodes by electroluminescence topography and transmission electron microscopy. The nonradiative regions, which spread out in the 〈100〉 direction during current injection, consist of a high density of dislocation dipoles and dislocation loops. The source of these defects is the preexisting stacking faults originating at the substrate/epilayer interface. The dipoles themselves are aligned along both of the 〈110〉 directions lying in the {111} plane. Their Burgers vectors were of the type (a/2)〈011〉 inclined at 45° to the (001) junction plane. © 1995 American Institute of Physics.
    Type of Medium: Electronic Resource
    Library Location Call Number Volume/Issue/Year Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...